It was a Wednesday, the 17th of July, 2024. But this quest actually began six years prior, in the summer of 2018. That year, I backed out of a different driveway, in a different state, on a vastly different motorcycle. But the goal had been the same - the tiny village of Tuktoyaktuk in Canada's Northwest Territories, on the shore of the Arctic Ocean.
I had a few new things going for me this time, which we'll delve into later, but Can-Am's smallest yet most rugged three-wheeler still seemed significantly more street-oriented than all my previous mounts. In the year I'd had it, I'd done a little gravel road testing in the nearby Black Hills, which had gone fairly well. But I knew that the 500+ unpaved miles of the Dempster Highway were infamously bad - the first 235 from personal experience (Attempt Two) and the rest from survivor reports. Was Ryker tough enough? Did it have enough ground clearance? Fender clearance? Tire tread? I really had no idea.
Then there were all the modifications I'd made to facilitate the packing of overnight gear, tools, repair parts, and extra fluids. Services along the Dempster are extremely limited. All of that was completely unproven. In some ways, I was less confident than on Day 1 of the other attempts. But I was more determined!
This is probably Belle Fourche, South Dakota. It's a logical place to fill up, as things get very rural, very fast after this - when you're headed northwest. That's my sleeping bag in the orange waterproof bag on Ryker's right side (your left). It's strapped to the passenger footpeg, which extends down from the rear of the driver's seat. My tent (rolled up in a black bag) is similarly attached to the opposite side. The windshield is an aftermarket add-on, as are the yellow handguards. I opted not to install heated grips this time, and hoped the guards would be enough wind protection to keep my hands warm on chilly mornings.
It was my first of nearly innumerable fuel stops. Though I suppose I could try... Some quick calculations just came up with around 70, minimum, for the round trip!
Oh, the black roll with the MC logo is my raingear. It's attached to the yellow drybag with straps that are sewn to the bag. Very nice. The red jugs on each side of the toolbox are what they appear to be. Each can hold 1.3 gallons of extra gas. I'll talk about their necessity and mounting later.
By the time I got to Ashland, Montana (on 212), the large shade cast by a spreading tree in front of the Health Dept./Sheriff's Office looked too good to pass up! I needed to take off my jacket so I could unzip all the vents and shed a layer underneath. The picnic table was a convenient bonus!
Aside from that, two wheels in front is a more easily maneuverable design than a bike with sidecar. Getting Ryker to go where I want to go and keeping it from going where I don't want to go requires much less effort. Hundreds of miles in, the difference is significant.
Thirdly, Ryker has cruise control! So the right hand also has ample opportunity for resting and stretching. My second KTM did as well, but Ural most certainly did not. And in both cases (left and right) it's not just the hand that benefits. By the end of the day, I can feel a reduction in arm and even shoulder fatigue as well.
The first day is for firsts! Here we have a cockpit view of the first of many road construction stops. The Northern Cheyenne Tribe was getting some beautiful fresh blacktop near Lame Deer. I'll use the pause to point out that the top edge of my windshield is not quite perfectly cut. Not bad though. In the weeks leading up to departure, I trimmed the brand new "glass" down twice in a friend's garage. His bandsaw proved the perfect tool for the job. It was the manual direction I gave it that was somewhat less than. But the result was just what I wanted - less airflow turbulence behind it, and more visibility above it. Thanks Rich!
Also, gotta love the reflection of Ryker's orange and yellow cowling stripes!
At some point after getting through that construction, I checked my mirror and noticed that my bottle of fuel additive was no longer in its spot on the left side of the drybag. I'd assumed it was gone for good - at least as far as I was concerned. If it survived the fall, maybe someone else would make use of it. I wasn't going back to look.
When I stopped for gas, though, I saw it dangling just above the rear wheel fender. It wasn't lost after all! Truthfully, I was more excited that I hadn't lost the bungee. It was a specific length that I had special ordered - harder to replace than the anti-ethanol treatment. I reaffixed it in its original location - with what I hoped was a better method.
I'll mention here, too, that that's the same leather saddlebag I had on the Ural (to the right of the wheel). Handcrafted by a dear friend in Tillamook, Oregon, it's just the right size for extra motor oil, engine coolant, and emergency tire sealant. And it brings a touch of classic style to an otherwise futuristic techno machine. I'm still adapting to Ryker's over-the-top aesthetic!
Though fully modern in most ways, Ryker does not have an on-board ambient temperature gauge. So I ordered this one and zip-tied it to the inside of the left handguard. It originally had a suction cup to adhere it to a house window, but I popped that out and strapped it on! I knew it would likely be affected by the sun and perhaps even by heat coming off the motor, but it still seemed like the best spot.
A temperature of 98F was NOT what I wanted to see displayed on my first (or any) afternoon. But I felt better realizing that the actual air temp was probably not that high. This was somewhere near Billings, MT. And I hoped it would be the hottest spot of the day - maybe my entire trip.
I'd left the house in Rapid City, SD, at a quarter after seven that morning. By roughly a quarter after eight that evening, I'd made it to Missoula, MT. Thirteen hours and 670 miles are not bad totals for a first day. I figured I'd have to average 450 per day to make it home in two weeks. Tuk was more than 3,000 miles away.
The cover was more to hide all my gear from prying eyes (and fingers) than for protection from the rain. It didn't look like there was any chance of precipitation. Of course, it wouldn't stop anyone who was determined to do mischief. But maybe it would discourage it. I had bought it for the Ural's sidecar, so the tub didn't fill up in an overnight deluge. And was pleasantly surprised to find how well it covered the most important parts of the Ryker.
As I've mentioned, I had all my camping gear with me, but it still hadn't cooled off. What I haven't mentioned yet is the smoke. Except for the first couple hours, I'd traveled in the haze and smell of wildfire smoke all day. It had never been extreme, but it still had not cleared up. And my dry, red eyes confirmed that fact. Camping in the heat and smoke was not at all a pleasing proposition. I also needed to get as much sleep as possible these first few days. I'd need it for the last few, I knew. Sleeping does not come easy in the Far North. At least not for me.
Food doesn't come easy for me up there either. But this is a Days Inn parking lot. At check-in, I was promised a hot breakfast in the morning! I began last year's truncated trip with a couple of less than stellar campgrounds and granola bars to start each day. Maybe hotel breakfasts are the key to a successful run to the Arctic Ocean and back. I was willing to give it a try.

Troy, very interesting. I'm anxious to read more. So glad you finally made it to Tuktoyaktuk. So what's next?
ReplyDelete